My sensaphone 400 doesnt seem to recognize zone 2, when I hit what is configure

Need a faster answer?
I'm assuming you are pressing [What is] [Status] for a status report or [SET] [Configure] for Zone configuration, If the unit skips the zone, this is a feature called "Designated a Zone as unused". It's a way to shorten the status report for Zones that you are not using and do not want to hear about. To Enable The Zone Again Press [Sensor on /off] + [SET] then the Zone number. This will enable the Zone again.
Was this answer helpful?
Yes
No
Thank you for your feedback!