2002 cbr 954 blowing fuse speedometer

asked by

on

30 Sep, 2017

  • 78%
    Solved this issue
  • 109min
    Time to fix
  • 59%
    Recommend to DIY
Need a faster answer?
Hi, Anonymous before diagnosing your blown fuse issue, check the bottom of your seat, if it's metal and comes in close proximity to the positive battery post you need to take the necessary steps to ensure there is no contact (electrical tape, thick rubber insulation, hammer a dent in the seat bottom etc.) You are going to need a wiring diagram from your service manual, a test light, an ohmmeter and plenty of extra fuses.
If you turn on your ignition switch and immediately blow a fuse you have a hard/dead short and is usually easy to find. With a test light connected to the hot side of the blown fuse holder start stabbing the wire/s that leads away from the fuse holder and towards the ignition switch, you test light will illuminate validating the short. When the test light fails to illuminate you have passed the short and need to back up until the test light illuminates, then look in the immediate area for the short.
If you driving down the road for 30 minutes or 15 miles and blow a fuse you have soft/flying short and may take some time and patience to find.
If the main fuse/circuit breaker constantly blows/trips while riding you probably have a faulty battery terminal connection. Check battery terminals for damage or corrosion, check battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. Any other fuses that constantly keep blowing while riding are usually caused by a loose or corroded ground wire in the circuit, which means you have to check, inspect, test each and everyone with an ohm meter set on a low ohm scale 100 ohms or less . Simply touch one lead to the ground source and the other lead to the battery negative terminal, a reading of zero indicates a clean solid ground. Any number reading or infinity indicates a poor ground and needs to be repaired. Poor or weak grounds require excessive additional amperage to complete the circuit which in turn blows the small amperage fuse.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
found this helpful answer from motorcycle mechanic on JustAnswer com
http://www.fireblades.org/forums/electronics/90265-cbr1000rr-07-keeps-blowing-10a-fuse-for-dash-speedo-display.html
Honda 954 Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR954RR Owner Manual
SHARE YOUR EXPERIENCE
  • Were you able to resolve it?
    Yes No
    Awesome !
    Ok
  • How long did it take to fix?
    Good to know
  • Is it better to DIY or Repair?
    DIY Repair
    Great
    Got it
Instant Repair Help
over the Phone or Video