D01CLR code on a 2000 classic harley Davidson Oil dummy light flashes on and off. Oil pressure gauge reads 28 at 2,000 RPM. Book says it should be between 30 and 38
19 Jun, 2015
77%Solved this issue
86minTime to fix
74%Recommend to DIY
Need a faster answer?
Hi Anonymous, start by checking oil level in tank and make sure it is between the add and full mark. With engine at normal operating temperature 180-230 degrees and the use of a 10 micron synthetic media oil filter, oil pressure will be 30-38 psi at 2,000 RPM and 3-5 psi. at idle. The oil pressure light is designed to come on at 2 psi. or less. To accurately test oil pressure remove oil pressure sending unit and install known good oil pressure gauge that reads 0-50, there might possibly be some plumbing required for hard to access points. If you are out in the middle of nowhere and there is no cell phone service and your oil pressure gauge isn't working and your oil pressure light is burned out, despair not, you still have one last line of defense left HYDRAULIC LIFTERS, as long as those tireless workers are quiet, you have oil pressure, maybe not much, but enough to get you down the road at a slow to moderate speed using the least amount of RPMS as necessary. Good luck Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...
SHARE YOUR EXPERIENCE
Were you able to resolve it?Yes NoAwesome !Ok
How long did it take to fix?Good to know
Is it better to DIY or Repair?DIY RepairGreatGot it
Instant Repair Help
over the Phone or Video
Get Instant Help
Save hundreds of $$$