Hi. I have an Optimus heater fan where the alarm light just stays on and there is no heat. I found this link on another forum stating that you can help, but not sure if I’m in right the place

Hi. I have an Optimus heater fan where the alarm light just stays on and there is no heat. I found this link on another forum stating that you can help, but not sure if I’m in right the place

How much does it cost

Hello Chris my name is Skip , I have a 60000 BTU multi-fuel Reddy heater bad work just fine until it ran out of fuel which I was using diesel, so I filled it back up and it ran for a little while and shut off and it just keeps doing this. I have taken it apart and and remove the fuel tip and taking it apart and blew it out, I have taken the hoses off and blown them out and even remove the pickup tube out of the tank and everything seems to be clear. I did wipe off the front of the little glass sensor and I changed out the fuel and and using kerosene now. I read an article where there's a little funnel shaped filter or something on the bottom of the pickup tube and mine doesn't have one of those but neither have I found any dirt in the system or in the tank. I have not messed with any of the pressure settings or anything like that, But it's still doing the same thing. Can you help me with this possibly or do I just have a demon heater on my hands LOL thanks for your help

I have a carrier mini split system and I’m getting a p6 error code only when one of the heads are running . There are 2 heads in the system but when I run them both it runs fine

I got a Sanyo model number one tooth St w1234 C2 PTAC unit and the it's not blowing heat is there a manual reset switch on it